The ST-LINK/V2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontrollers. The single-wire interface module (SWIM) and JTAG/serial wire debugging (SWD) interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board. In addition to providing the same functionalities as the ST-LINK/V2, the ST-LINK/V2-ISOL features digital isolation between the PC and the target application board. It also withstands voltages of up to 1000 Vrms.
Specification
| Power Supply |
5V supplied by a USB connector |
| Interface Compatibility |
USB 2.0 full speed compatible interface |
|
USB standard A to mini B cable |
| Voltage Support |
SWIM Interface: 1.65V to 5.5V application voltage supported |
|
JTAG/SWD Interface: 1.65V to 3.6V application voltage supported, 5V tolerant inputs |
| Modes Supported |
SWIM low-speed and high-speed modes supported |
| Direct Firmware Update |
Supported |
| Status LED |
Blinks during communication with the PC |
Package Includes
1 x ST-LINK/V2 debugging and programming Unit
1 x USB standard A to mini B cable
1 x Connecting Cable for STM8 SWIM and STM32 JTAG/SWD protocol
1 x Flat ribbon with a standard ERNI connector at one end (A JTAG or SWD and SWV flat ribbon with a 20 pin connector)
